I Can't configure Inputs beyond 2 - resolved

I had no problem configuring inputs 0, 1 and 2, but when I try to configure any of the other inputs, there is no save button, only a Cancel button. How can I fix this? I tried cycling power to no avail.

Would you post a screenshot of the input with only the cancel button?

Just to be clear, entering data does not add the save button

OK, two different problems here:

In the first screen, you have specified a generic CT but have not provided an acceptable turns ratio. Note the message “Range is 100 to 18000.

In the second screen, the name contains a blank. Valid names have upper case, lowercase, digits and the underscore “_” character. Note the message “Invalid name”.

Thank you for the prompt diagnosis. My Bad.