Rogowski coil support

[overeasy]

I’ve tested and several users have used the Emporia rogowski coils. See these posts:

Flexible CT Sensor

I have an older panel with very limited room in it. There is no way I can get any type of CT sensor on the mains lines other than a flexible Rogowski type. Without doing too much homework I purchased the Emproia one, thinking it would work since it has a built in integrator, but now I see others asking about it and being told it will not work. It DOES pull in information to IotaWatt, but it’s just not accurate, and I’m not sure what custom settings I would use for it. Anyway, true question, is …

Emporia Rogowski Coil setup for IotaWatt

Hi, I have a main panel with very limited access to one of the main wires, no way to get a regular CT on it. I see in this thread there was some good success with getting the Emporia Rogowski Coils (RC) to work: I just wanted to make sure I configure it correctly as there seems to be slightly different instructions in the 2 posts from @Overeasy on making it work. Instructions: Step 1: remove burden resistor from the relevant input inside IotaWatt. Step 2: set burden resistor value in conf…